Need specs for L5 12inch Kicker Speaker Box

[pioneer 10+ year member]

Originally posted by Jmac Construction Material = .75" MDF

Box Height = 14"

Box Width = 24"

Box Depth = 12"

Number of Ports = 1 (Slot)

Diameter of Ports = 12.5" x 1.25"

Length of Ports = 28"

Port Area = 15.625 square inches

Box Volume = 1.217 ft^3

Box Tuning = 33.23 Hz

WinISD Estimated Peak SPL = 66.2 Hz

WinISD Estimated 3 dB Down Point = 46.7 Hz

WinISD Estimated Peak Port Velocity (650 watts) = 32.79 m/s @ 20 Hz

ok so this is for the 12 L7 right ? //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

thanks so much man...u saved me alot of trunk space

loud and clean right ?

 

[pioneer 10+ year member]

Originally posted by Jmac Yup, L7 loud and clean (If done right) //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

u mean if the box is made right ?...well i have trust in my tech...so he shoudl get working on this tomorrow

i listen to rock,rap,techno...will this box be good for me ?

would polyfill help in anyway?

i think my sub is completely broken in...the cone moves very easy now and the entire spider moves

 

[pioneer 10+ year member]

Originally posted by Jmac I doubt polyfill would make any difference and it could cause a problem if it gets blasted into the port hole and stuck ... I wouldn't bother with it ...

 

I think it'll be good for you. It shouldn't have a problem going down to 30 Hz ... It might be a little non-linear from 25-30 Hz, though ... //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

what do you mean non-linear ? //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

 

[pioneer 10+ year member]

Originally posted by Jmac Not accurate and out of control ...

would this be a bad thing and hurt my sub ?

//content.invisioncic.com/y282845/emoticons/frown.gif.a3531fa0534503350665a1e957861287.gif

 

[pioneer 10+ year member]

Originally posted by Jmac If you didn't have the subsonic filter set @ 25 Hz, I would say so.

 

However, it will probably just result in worse sound quality and slower response from 25-30 Hz. I doubt it will bottom out, especially since you're only running 650 watts ...

ok thanks very much again //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

but will this jbl put out anything more than 650 @ 4 ohm ?

i was lookin at a test from carstereoreview mag...this is what it said

841.1 W @ 4 ohms -14.4V

1378.1 W @ 2 ohms-14.4V

683.8 W @ 4 ohms-12V

1039.7W @ 2 ohms-12V

Tested by Ken C Pohlmann

 

[pioneer 10+ year member]

hey jmac...would this box be able to play lowww bass ?

my tech was looking at it and he said that will play higher bass tones

what do you think ?

 

[pioneer 10+ year member]

hey thanks alot

how will a 2.5 cubic foot box sound ?...this includes the speaker displacement but not the port volume

 

[v8s10 10+ year member]

hey jmac... can you do the same for down to 20 htz???? i got a single L7 that i just want to meet every note with open arms.. and i being a producer tend to use the 22 htz range for the REAL low dance beats... let me know some dimensions please..

 

[v8s10 10+ year member]

2 foot by 3 foot by 2 tall... thats a very rough estimate... i need a BIT of space for groceries and such.

 

[v8s10 10+ year member]

also im removing the stock seats and installing after market seats, so i have some room to adjust...

basically i have about 4 cubes to work with max.

 

[v8s10 10+ year member]

depth = 16

width = 25

height = 23.5