Need some assurance on my subs to amp wiring

[mrpep]

I just got a new amp so I'm not very familiar with it . The amp is a hifonics zrx-2416.1d and my subs are dvc that are now wired together to 1 ohm. The amp has two inputs and this where my uncertainty comes in... the 2 subs are wired together as 1 at 1 ohm and the amp has 2 input terminals in the manual , see this picture below:

So if I'm correct , I would wire them monoblick single subwoofer since both of my subs are wired as one and the amp should acknowledge that it's a 1 ohm load and throw the watts of a 1 ohm load at my subs , right ?

Sent from my iPhone using Tapatalk

Click to read more...

 

[CSCStang]

Ummmm...does it say it's 1 ohm stable? Usually not when you have to bridge channels.

 

[mrpep]

Sent from my iPhone using Tapatalk

 

[mrpep]

I take it I'm set up ok, things are bumping hard and heavy

Sent from my iPhone using Tapatalk

 

---------- Post added at 06:29 PM ---------- Previous post was at 06:29 PM ----------

 

I need a downloadable 60hz tone that I can play on iPhone

Sent from my iPhone using Tapatalk

 

[joom 10+ year member]

You can wire it like either one of the lower pics as the outputs are parallel with one another. The upper pics do not apply to your amp.

 

[mrpep]

I tried to tune using a 60hz tone from YouTube but voltmeter only got up to 13 volts - that can't be right

Update: I don't even know what I'm tuned to but it's not clipping and I can max the gain and still no clipping. These sundown SA 12"s combined are supposed to use 1500 rms and if I crank the amp all the way it should be 2000 watts from the amp so I maxed it out , no clipping and then backed off a bit so should be safe , I hope, lol

Sent from my iPhone using Tapatalk