Need help with wiring and installation

[Red Rocket 10+ year member]

I'm a noob to car audio so forgive my dumb questions. I know this isn't the best set up but most of it was a gift and it's not that bad for a first system I suppose. I have no idea what size wiring and everything else that I need to install the stuff below. It's going into a 1994 Pontiac Bonneville SSEi. Also, will I need more power or am I okay with my current battery?

Subs are:

Model Description...........................BTL10X3 10" Tri-Sub Enclosure

Impedance.....................................4 ohm

Power (W) RMS/Total....................750/1500

Frequency Response....................43Hz - 150Hz

Sens...............................................92.2dB

Dimensions (H x W x D)................ 13 1/4" x 35 1/4" x 14 1/2"

Amp is:

Audiobahn A8002T

RMS Power: 200W x 2

Bridged RMS Power: 800W x 1

THD at Rated RMS Power: 0.02%

Speaker Level Inputs: No

Preamp Outputs: Yes

Built-In Crossovers: HP/LP

Bass Boost: 0-18 dB

Frequency Response: 10-40,000 Hz

Channel Separation: n/a

Signal to Noise Ratio: > 100 dB

Fuse Rating: n/a

Click to read more...

 

[creater 10+ year member]

looks aite for a first setup mang...you should run it and see if you're getting significant power loss...if you are getting significant power loss then you should do a big 3 or get a new battery...you can run 4 or 8 guages to the amp...

 

[Red Rocket 10+ year member]

looks aite for a first setup mang...you should run it and see if you're getting significant power loss...if you are getting significant power loss then you should do a big 3 or get a new battery...you can run 4 or 8 guages to the amp...

It doesn't matter if it's 4 or 8? Also, any names I should look for/stay away from?

 

[Chevyaudio 5,000+ posts]

I would run 4 gauge, some people might tell you to run 1/0 gauge, but only do that if you seriously intend on upgrading to larger amps in the future. In my older setup. I ran the A800T pretty good little amp for the price, I ran it at 1.5 ohms for over a year, worked like a champ until the day i unhooked it.

 

[Red Rocket 10+ year member]

I'm assuming this wiring kit would work fine?

http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=5791842992&category=71528&rd=1

 

[RandyJ 10+ year member]

dunno, says the url is invalid

 

[Red Rocket 10+ year member]

dunno, says the url is invalid

My bad. Fixed the link now.