I am planning to put a system in my car but I dont know what type of box to use I have a 96 prelude (trunk) and i was thinking of doing a ported box with the ports running up to my rear panels where the 61/2s are so i would have to cut a whole on the metal tell me what you guys think of this idea by the way my subs are 2 12's DB drives each will be run by DB drive amps one for each woofer which each will have 500 watts each
-
2Participant count
-
Participant list
MikeofTulsa Moderator
The one and Only!
it truly depends on the sub....some subs are great subs and you dont have to spend a god awful amount on them....good luck
Activity
No one is currently typing a reply...
Similar threads
Ya man. That will work just fine
- Started by sounds_explicit
- Wiring, Electrical & Installation
But since you guys are still here, I have another question. Now that I have a 3k amp, after I get my new battery and HO Alternator, I'll be in the...
- Started by Blackout67
- Amplifiers 17 18 19
currently I am using 4g wires for my ground and power (1-1.5ft for ground and like 16ft for my power) and no I did not sand the area for the...
- Started by Maddoxp07
- General Car Audio
Sony 4000 is also a great budget buy!
- Started by Arizreynoldsxxxx
- Head Units
How I would approach it is install your new amplifier and start using it.
Install a voltage gauge and if you see your voltage lowering then add...
- Started by Ellessucs
- Wiring, Electrical & Installation
About this thread
