crzybob77 10+ year member
Member
Alright, i am going to be getting two 12" single 4ohm voic coil subs. I want to wire them as a 2 ohm load on my amp to get the most out of my class D mono amp. I know that they need to be wired in parallel to do this. I talked to some people at crutchfield about the wiring diagram that they have one their site :
http://www.crutchfield.com/infocenter/car/S-wx2Z5XtM7R7/amplifiers_faq.html
It is near the bottom of the page.
I want my amp to be 1 channel (bridged). So, they said to put 2 wires into the positve and 2 wires into the negative terminal on the amp and then take those 4 wires and hook them to alll the positive and negatives on the sub. They said this will make a bridged 2 ohm load. Does this sound correct?
http://www.crutchfield.com/infocenter/car/S-wx2Z5XtM7R7/amplifiers_faq.html
It is near the bottom of the page.
I want my amp to be 1 channel (bridged). So, they said to put 2 wires into the positve and 2 wires into the negative terminal on the amp and then take those 4 wires and hook them to alll the positive and negatives on the sub. They said this will make a bridged 2 ohm load. Does this sound correct?