Need advise from the experts

  • 3
    Participant count
  • Participant list

tipllub

Junior Member
4
0
Texas
First off I'm new here.......and hope that my question is in the right place. I have stuff left over from different cars I have had in the past and u was considering putting these pc all together in my current car. I have 1- 06s12l74,1- ss components, 1- ss mids, 1- zr120, 1-zr240, 1- zr360. My current ride is an avalache so I was going to build box in bed and take midgate out. I would like to use all this stuff because it's just setting around. Any and all suggestions or recommendations welcome.

 
I think the 360 was around 600 the 240 was around 500 and can't remember on the 120. The zr amps were way underrated that the remember for sure. I know to get that power I would need another sub to drop the ohm load or just get another amp. I'm not looking to compete but rather just a good solid daily system. Oh and I will have a ported box for sure

 
What are your components and subwoofer brands??What ohm load is the sub,and is it a DVC4/2ohm?, or a SVC 4ohm sub,and what are the dimensions of the enclosure? Cuft/tuned to as to HZ, or is it a prefab bought enclosure,that is important to try figure out what you have and what you are to accomplish to get the best out of what you have, as well as if you need to even add a sub, or just a better made built enclosure,ect?What Stereo Head unit are you running?ect..

 
Do you have the sift cards for the amps ,assuming you are speaking of the Kicker ZR amplifiers?What ga is your power supply to the amps, do you have a High Output alternator(HO alt) stock, 1 battery/2 batteries,what kind of battery/size,have you done the big 3,do you have a pre amp eq?or a xover at all ect?

 
Kicker zr360

Kicker zr240

Kicker zr120

Kicker ss 56.2 components

Kicker ss mb6 mids

Kicker 06 model 12" L7

I have all this from yrs ago and different pieces were in difference cars I used to have. It has never been in anything together. At this time is is still not in anything. There is not a box built yet but room is not an issue so it would most likely be built to specs. Not I don't have any sheets on the amps. Alt and batteries are something I would get if I go ahead with this. Wiring I have a good amount of all different size wires and a few caps as well. What I'm trying to find out is if this would work good all together or would I better better off Getting a second component set for rear doors and bigger amp for subs. Because the amp that ran these subs is gone and was way bigger. The subs one of these amps ran are gone and were 2 8".

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

How I would approach it is install your new amplifier and start using it. Install a voltage gauge and if you see your voltage lowering then add...
4
373
You can just change the surround if the cone is not broken. This picture shows all the measurements you must make.
1
768
Lifelong Pioneer Premier series user here. Switched to the Kenwood eXcelon Reference (XR) DDX9905S and never looked back. Excellent sounding...
9
487
Very nice to hear you found what you needed to get your audio system/ect. up to your needs. we appreciate the information provided in this thread...
4
410

About this thread

tipllub

Junior Member
Thread starter
tipllub
Joined
Location
Texas
Start date
Participants
Who Replied
Replies
9
Views
1,155
Last reply date
Last reply from
tipllub
1717274743729.png

Doxquzme

    Jun 1, 2024
  • 0
  • 0
Screenshot_20240531-022053.png

1aespinoza

    May 31, 2024
  • 0
  • 0

New threads

Top