Need a push in the right direction

[MerkConvoy501]

Anybody have a good write up on how to build dividers in ported boxes. I use re box calculator but need to look into how to make 1 box with a divider.

Click to read more...

 

[mylows10 5,000+ posts]

The re calc sux use Torres. It's better

 

[MerkConvoy501]

The re calc sux use Torres. It's better

I will look into it

 

[MerkConvoy501]

The re calc sux use Torres. It's better

Looked into and it is confusing

 

[mylows10 5,000+ posts]

Looked into and it is confusing

It's actually. More accurate. Because it wants the sub specs. Re calc is off by 5-6 hertz

 

[MerkConvoy501]

It's actually. More accurate. Because it wants the sub specs. Re calc is off by 5-6 hertz

You think there tuning is off by that much? High or Low

 

[mylows10 5,000+ posts]

You think there tuning is off by that much? High or Low

Yes usually high

 

[MerkConvoy501]

Yes usually high

How do you feel about using to of the exact same boxes instead of one big one?

 

[mylows10 5,000+ posts]

How do you feel about using to of the exact same boxes instead of one big one?

Sends on what your trying to do. Some cases it works fine. Others not so well there are builders who can design a box for you. With a cut sheet

 

[MerkConvoy501]

Sends on what your trying to do. Some cases it works fine. Others not so well there are builders who can design a box for you. With a cut sheet

I was running two twelves and loved that box thinking of building another and using two boxes instead of one 4 12 box

 

[mylows10 5,000+ posts]

I was running two twelves and loved that box thinking of building another and using two boxes instead of one 4 12 box

What subs ? What car ? How much power ?

 

[MerkConvoy501]

What subs ? What car ? How much power ?

99 Blazer 4 kenwood xw 12 400rms a piece prolly running around 1200rms

 

[mylows10 5,000+ posts]

Build one box

 

[MerkConvoy501]

Build one box

What makes you recommend one box when looking at my equipment?

 

[mylows10 5,000+ posts]

If your trying to get more from what you have. Then a single chambered box. Sub up port back in the center will give you the most output. Some people call this box a Steve Meade box