My false floor is almost complete...

[focused313 10+ year member]

I was going to do the Omega symbol but decided that since their was a large one on the box that I would do the Fj symbol on both sides. I messed up the one piece of Lexan so I might change it when I redo it.
I used this Lexan....

Amazon.com: Polycarbonate Sheet, ASTM D 3935, Clear, 1/4" Thick, 12" Width, 24" Length: Industrial & Scientific

and these LED's...

Amazon.com: Flexible Lighting Strip 300 SMD LED Ribbon 5 Meter or 16.4 Ft 12 volt BLUE, 2026BU: Home Improvement

I used my table saw to cut it to 8" x 8" squares then taped it off and drew/traced the design. Then I used a utility knife and straight edge to cut out the design, leaving the design and removing all the excess tape. I used my Dremel multi-max with the sanding attachment to frost it. It went very quickly and I used a straight edge to get up to the tape (even if you hit the tape its okay). Then remove the tape and wipe it down with alcohol. Very easy to do.

thanks for that info.

 

[Goindef154 5,000+ posts]

That looks great, good job man.

 

[OmegaBunny 10+ year member]

Thanks. I have my sub, amp, and second installed and wired. I have my wire ran for the front stage and some Audio Technix on the way so this weekend I will get my front stage installed and hopefully a video or two.