muskyhunter567 10+ year member
Truck Do Burn Rubber
- Thread Starter
- #31
and p.s. caddilac matt look into 4th order bandpass with the port facing right at the armrest, i saw a set up on ROE like that, VERY NIIICE!
I been curious about doing something like that as well in my car.I would love to see that. I even thought about removing my rear seats and doing a simple setup with (2) 18s in its place.and p.s. caddilac matt look into 4th order bandpass with the port facing right at the armrest, i saw a set up on ROE like that, VERY NIIICE!
basically just make sure there are no leaks into the trunk. any opening allowing pressure out of the cabin takes away from the spl. some people baffle it off, others might use expanding foam, but I used a ton of sheets and stuffed them in all of the openings. thats the easiest way and probably least effective, but if you want to see how it will sound with the trunk sealed off it is not a bad alternative...how do you properly seal the trunk?
Like... bed sheets?basically just make sure there are no leaks into the trunk. any opening allowing pressure out of the cabin takes away from the spl. some people baffle it off, others might use expanding foam, but I used a ton of sheets and stuffed them in all of the openings. thats the easiest way and probably least effective, but if you want to see how it will sound with the trunk sealed off it is not a bad alternative...
and p.s. caddilac matt look into 4th order bandpass with the port facing right at the armrest, i saw a set up on ROE like that, VERY NIIICE!
Did you eleminate trunk rattle altogether then?before i sealed the trunk I tested my idea by taping the boards into place just to give me an idea if I was headed in the right direction. Had to re tape after every test LOL but it worked.
My trunk is sealed but its with the box pushed all the way to the trunk lid. Wooden floor and 2 sides and a top added to the face of the box to extend it to the back of the b pillar. There I used lots of foam, tape, silicone, more foam etc. to seal each leak I found.
Now when I open the trunk the sound doesnt change. All you hear is the box flex and my MOMO 6 x 9's.
Did you eleminate trunk rattle altogether then?
Don't forget about mike stiers too. //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gifTim Schelnut (sp?) built up some loud trunk designs. Dave DaSilva also had a nice trunk design. Both used 1st gen neons and were farting out 153-155 dB