neo_styles 10+ year member
AKA Pop Twidget
Hope I can get an answer here...
I recently picked up an ID10 d4 in a sealed enclosure and am about to snatch up a Rockford RF8004 (replacement for a DOA traded MB Quart 1200.1d). Since the Rockford's not stable bridged at 2 ohms, I wanted to see if I could wire each voice coil separately. End result would be running each voice coil on a bridged channel for the RF8004.
Problem is, I've been looking around for a terminal cup that was both round and contained 4 posts and haven't been so lucky. Does anyone know of a source or possible solution? The box already had a round cutout and a 2-terminal post installed.
I recently picked up an ID10 d4 in a sealed enclosure and am about to snatch up a Rockford RF8004 (replacement for a DOA traded MB Quart 1200.1d). Since the Rockford's not stable bridged at 2 ohms, I wanted to see if I could wire each voice coil separately. End result would be running each voice coil on a bridged channel for the RF8004.
Problem is, I've been looking around for a terminal cup that was both round and contained 4 posts and haven't been so lucky. Does anyone know of a source or possible solution? The box already had a round cutout and a 2-terminal post installed.