LOC or DSP For Factory Radio

  • 3
    Participant count
  • Participant list
A LOC converts headunit power to rca power so you can run an amp. A DSP is a powerful tuning device that gets used after the head unit rca to tune the signal. A loc is the only way to get a rca output for an amp

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

You can just order any as long as it has speaker inputs helix and audiocontrol has both
10
2K
Yeah tapping off the 4 gauge is typically fine. However, you need to fuse the smaller wire right by the 4 gauge at 1 amp (or whatever the small...
3
755
Thanks for the link to this video, I've seen this one before but it's not for component speakers which is what I'm going to install and the part...
4
566
You should run all exact matching subwoofers in one singular enclosure and 1 amp or matching amps for the best listening experience for the space...
11
1K
There are a couple that SMD has tested, around $20.00 that should take the wattage from most any HU. If you are tapping into the speaker wires...
3
1K

About this thread

Mr.Jackson

Junior Member
Thread starter
Mr.Jackson
Joined
Location
Stone Mountain Ga
Start date
Participants
Who Replied
Replies
3
Views
849
Last reply date
Last reply from
LosIsATool
IMG_1315.jpeg

vlusardi

    Apr 27, 2024
  • 0
  • 0
pattern-wavelength.jpg

winkychevelle

    Apr 27, 2024
  • 0
  • 0

Latest topics

Top