LOC install in 09 chevy silverado help

  • 3
    Participant count
  • Participant list
if you want to stick it in the kick then you'll have to grab the speaker wires running in from the door through the grommet. Tan is your + and Gray is -

 
Should i just grab them behind the deck instead, what is the best way thanks for your help
it all depends on where you want your rcas to come from if your installing in the rear i would just splice into the wires back there so you only need like a 3 foot set of rcas

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Yeah tapping off the 4 gauge is typically fine. However, you need to fuse the smaller wire right by the 4 gauge at 1 amp (or whatever the small...
3
766
Thanks for the link to this video, I've seen this one before but it's not for component speakers which is what I'm going to install and the part...
4
574
You should run all exact matching subwoofers in one singular enclosure and 1 amp or matching amps for the best listening experience for the space...
11
1K
There are a couple that SMD has tested, around $20.00 that should take the wattage from most any HU. If you are tapping into the speaker wires...
3
1K

About this thread

Bigpook

Junior Member
Thread starter
Bigpook
Joined
Location
Plano TX
Start date
Participants
Who Replied
Replies
4
Views
670
Last reply date
Last reply from
DammitJames
fixed.jpg

Popwarhomie

    Apr 29, 2024
  • 0
  • 0
done.jpg

Popwarhomie

    Apr 29, 2024
  • 0
  • 0

Latest topics

Top