Little bored today

Wonger
10+ year member

Senior VIP Member
430
0
eBay
Well with nothing to do I got an idea, but I need some suggestions first. I have a CVR with a broken motor. The magnet is cracked all the way around and is offset by about a millimeter. I was going to take it and pound on it with a rubber mallet to see if I could reset it. Any tips, tricks, rants, suggestions, etc.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

They should work. I have 6.5s in my lower door to replace the 8" subs that came with my mustang. They are fantastic, and outperform the 6 x 8s...
3
1K
Well lets say I was running the tablet and 3 amps, would I use something more along the lines of a line output converter so that I would be able...
12
2K
Dammned that sounds good!! I usually dont eat out. But Hmm. Tempting
91
5K
Not using the bass knob but amp to the touch,barely warm after 30 minute ride Edit: not going full tilt for that long either.way too loud for that...
9
2K
This afternoon when I got in my car it took a few seconds for my subs to start working. I figured it’s because I’m in Florida and it’s...
0
360

About this thread

Wonger

10+ year member
Senior VIP Member
Thread starter
Wonger
Joined
Location
eBay
Start date
Participants
Who Replied
Replies
6
Views
459
Last reply date
Last reply from
oxygen65
20240519_201344.jpg

audiobaun

    May 19, 2024
  • 0
  • 0
Screenshot_20240519-213549.png

1aespinoza

    May 19, 2024
  • 0
  • 0

New threads

Top