Jacob's Wall Build Log

[power-fanatic07 5,000+ posts]

should be nice....seems like everyone is doing 4th orders now

 

[sundownz Pro Seller]

Framed the back wall into place on the front (also framed into place on the back as pictured before) -- starting to frame in to place the woofer baffle in :

Back chamber is 5 ft^3 before the displacement of the 2x4" lumber + any other bracing I decide to add. Figure I'll end up with around 1 cube per driver as I plan to reverse mount the subs (no sub displacement).

 

[ngsm13 5,000+ posts]

Tits.

nG

 

[sundownz Pro Seller]

Cross brace finished for the baffle... just need to build the baffle itself now :

Looks pretty strong to me //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

 

[sundownz Pro Seller]

Looks like I will be trying four 12s first -- not sure if I updated and made that clear in any of the posts yet.

 

[S.B.C. 10+ year member]

Someone wasted a lot of time building that. Good luck with your build.

it did 160- youve never come close to that //content.invisioncic.com/y282845/emoticons/laugh.gif.48439b2acf2cfca21620f01e7f77d1e4.gif

 

[Annnarbor84 5,000+ posts]

it did 160- youve never come close to that //content.invisioncic.com/y282845/emoticons/laugh.gif.48439b2acf2cfca21620f01e7f77d1e4.gif

Lawl

 

[sundownz Pro Seller]

Nothing new on the build yet -- back to work during the week so I won't have much time //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif Want to try and get the baffle made at some point, though!

 

[blackxj 10+ year member]

looks good

 

[audioarsonal 10+ year member]

Jacob I would try and make the rear chamber a little bigger like 2 cube per woofer.You could always shrink it but I think you will get better numbers with 2 cubes then 1 cube.How large will the front chamber be?

 

[DB-Audio 10+ year member]

looks nice and strong good job so far

 

[sundownz Pro Seller]

Front chamber will be pretty huge -- 32 cubes or so.

 

[audioarsonal 10+ year member]

Have you figured out how much port area your gonna go with?That should be a low end monster if you get it dialed in right.//content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif

 

[power-fanatic07 5,000+ posts]

Front chamber will be pretty huge -- 32 cubes or so.

//content.invisioncic.com/y282845/emoticons/wow.gif.23d729408e9177caa2a0ed6a2ba6588e.gif

 

[sundownz Pro Seller]

I am going to start with it wide open and then measure the peak and adjust accordingly //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif