Is this the right choice?

Would these work also?

M1d

M2c

Another rookie question I have is say I wire it to 3ohms and use the JL HD1200. With box rise using the HD 1200 after 4ohms what will the amp do? The amp only puts out 1200rms between 1.5-4ohms

 
Last edited by a moderator:
Would these work also?
M1d

M2c

Another rookie question I have is say I wire it to 3ohms and use the JL HD1200. With box rise using the HD 1200 after 4ohms what will the amp do? The amp only puts out 1200rms between 1.5-4ohms
doubt anyone has ever tested it below that could be 8-900 or so.. get the twisted man

 
Would these work also?
M1d

M2c

Another rookie question I have is say I wire it to 3ohms and use the JL HD1200. With box rise using the HD 1200 after 4ohms what will the amp do? The amp only puts out 1200rms between 1.5-4ohms
why would you wire it to 3 ohm? with the impedance variance it wouldn't quite give it full power but still will give it a good deal of the 1200 watts!

if you can wire the m2 down to 1 ohm its a great amp.

 
Would these work also?
M1d

M2c

Another rookie question I have is say I wire it to 3ohms and use the JL HD1200. With box rise using the HD 1200 after 4ohms what will the amp do? The amp only puts out 1200rms between 1.5-4ohms
rise is usually double or tripled wired impedance so you are still not getting anywhere near 1200 watts. try 600-800 watts, you are never getting the power you think you might get, rise is a b*tch. Thats why I recommended a korean amp to wire to .75 ohms so you actually get around 2 ohm power after rise.

 
So that twisted sounds 1.8k is good or Is there a better choice or maybe even a 2k amp?
So will the twisted sounds 1.8k do sound 1000 to 800rms?
The ts 1.8k is not 1800 watts. Its way more. Didnt you watch the video i linked of the 2.8k dyno? Rated for 2800 watts but did almost 4000 watts. At .75 ohms you!ll get plenty of power

 
First off I want to say hi to everyone as I'm new to the forums. I wanna do a simple and clean install in my 2015 Lexus IS350. Im thinking about either 1 12" or 2 10s and no greater than 1500RMS to the subs.
I have a chance to grab a JL Audio 13W7 for $375 just for the sub. I was thinking of getting it and placing it in a 2.5 net cubic box tuned to 34 hertz. And for a amp I'd probably just pick up a JL HD 1200.

This got me thinking though. With that size box I could run 2 10s but lower RMS rating between 600-750. The box could also be a bit bigger between 2.5 - 3 cubes net and tuning would be the same 34 hertz or maybe go down to 32 hertz. As for power I was thinking a true 1500RMS amp like the Rockford Fosgate T1500BDCP. I saw this box online and think its pretty good? What would you do? Take the JL W7 or go with 2 10s? I want it to be clear loud and hit lows. I do listen to rap music mostly but also listen to indian music.

Ported Dual 10" Subwoofer Enclosure - SSA STORE

My choices for the 2 10s would be

JL Audio W6v3

MTX 9500 (silver ones)

Sundown SA

DC Lv3

Alpine R Series (2017 model)

Soundqubed HDS2.1
grab the W7

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

While we're speculating, why not bump up your volume gain (no pun intended) for just a few dollars more (literally) and go with the 8" versions of...
5
958
Hello, I already posted in general but wanted to also post in here. I recently installed a set of used JL audio shallow depth 12W 1v3-4 inside an...
0
793
Makes sense. You may be right on the gain; 2 subs on 300 watts seems anemic.
46
4K

About this thread

IS350

Junior Member
Thread starter
IS350
Joined
Location
Los Angeles, CA
Start date
Participants
Who Replied
Replies
42
Views
2,527
Last reply date
Last reply from
Jeffdachef
1715565471722.png

Doxquzme

    May 12, 2024
  • 0
  • 0
IMG_5880.jpeg

Brendon Jenness

    May 11, 2024
  • 0
  • 0

New threads

Top