vandiar2
10+ year member
Senior VIP Member
the load i am putting on it. today I sanded down all of my grounds really good with a bearpaw. ran a straight 1/0 cable from the batcap 2000 in the back to the battery in the front. my voltage is still dropping to about 11.8 at the amps. curious, I then turned my engine off and turned my volume up until about 37.. (full tilt is 48) tested at the amps and before i ran to the front to turn it down so i don't throw my amps into protect mode.. I seen it drop as low as 11. what is my next move here. Thanks!
