i have a kicker amp question

[yu12bme]

I Have 4 15 Inch Kicker Cvx Subs (all Are 2ohm) And I Have 2 Zx 1500.1 Kicker Amps...is It Possible To Wire It So I Can Get The Full Wattage Or Since The Subs Are Already 2ohm The Load Impediance Will Dop To Low For The Amps To Work Properly.. My Ideal Was To Place 2 15s On Each Amp In Side My Armada Or How Should I Wire ..if Possible Need Suggestions Fast ..thanks

Click to read more...

 

[adam007 10+ year member]

double post ahhhhhh

 

[yu12bme]

what is double post???

 

[Bosaliniee 10+ year member]

not sure if i know what double posting isunless he means this, but you can wire 2 subs in series and wire that parallel to the other 2 subs in series and have a 2 ohm load

 

[yu12bme]

thanks

 

[Bosaliniee 10+ year member]

hold on wait, i figured out the double post thing, its because you have posted the question 3 times, but i read in another that these are dual 2 ohm speakers, the way i just said will give you a 1 ohm load, if they are all wired the same way(single sub parallel or series) you will have to use 2 subs on one amp and 2 on the other, you cant strap them, i would wire the subs all in series and then put 2 in parallel per amp for a 2 ohm load like the diagram on your other post

 

[yu12bme]

whats can i do ..they are duel voice coil 2 ohm subs

 

[Bosaliniee 10+ year member]

look at your manual for your speaker, wire it as the series sub which would make it a 4 ohm sub, then take 2 of them and hook both of negatives to negative and both positives to positive and do the same for the other amp

 

[t-money 10+ year member]

hold on wait, i figured out the double post thing, its because you have posted the question 3 times, but i read in another that these are dual 2 ohm speakers, the way i just said will give you a 1 ohm load, if they are all wired the same way(single sub parallel or series) you will have to use 2 subs on one amp and 2 on the other, you cant strap them, i would wire the subs all in series and then put 2 in parallel per amp for a 2 ohm load like the diagram on your other post

actually, you can strap the two zx1500.1's. however if all subs are dual 2 ohm, just wire two in series to get 4 ohms each, then wire them parrallel to the amp for a 2 ohm load. So you can wire two subs to each amp and get a 2 ohm load, which is what the amps are rated at.