How would you guys wire this?

[jarnld 10+ year member]

I have the following that Im putting in my car. Here is what I was thinking. Tell me what you would do.

MTX 4 channel 65X4@2ohms

Rockford Fosgate 400s

JBL 6.5

Jbl 5 1/4

Sony tweeters

I was going to run the front JBL 5 1/4 speakers out channel one on the MTX in parallel to bring them down to 2ohms. Set the front crossover for those.

I was going to run the 6.5 out channel 3 (rear) in parallel (2 ohms) and set the crossover for those.

Then I was going to wire the RF amp from the MTX using the 'sum out' RCAs and run 2 12" Kenwood subs. These are going to be wired in parallel and bridged.

How would you all reccomend hooking up the tweeters (built in crossover at 5K)?

Also, Im using 4 guage wire from the baterry and running that into a fused dist block and then out to the amps using 8 ga wire. Same with the ground wire. The amp remotes are being individually hooked up to the amp relay wire from the HU (Sony xav-7w). The HU also has a HPF LPF and 3 RCA outs (front rear and sub).

Any suggestions or improvements? Tweeters?

Click to read more...

 

[creater 10+ year member]

to be quite serious i dont like sony tweets...get some JBL or Image Dynamics tweets...

 

[jarnld 10+ year member]

Hey now... there is already a thread where people ar ragging on me for the sonys....I like how they sound. So aside from that....?

 

[johnecon2001 5,000+ posts]

so basically.. your not going to have any stereo image up front or in back at all? that sounds retarded. Screw 2ohms. wire them normally and get a stereo image up front. I guaruntee it'll sound like total *** if you keep it mono..

 

[jarnld 10+ year member]

****...im retarted...i didnt think about that. Crap. Like I said before...Im great at box designs and fabrication stuff...but when it come to the electrical/speaker installation side of things I just dont know a whole lot.