gp3000 help

[stork90 10+ year member]

Ok so everything was working fine then suddenly stopped putting anything out to my subs. Amp comes on, no protect, but also no output. Nothing smelled burnt or anything.....any ideas?

Click to read more...

 

[mclerico83 5,000+ posts]

power supply of amp is gone. whats your electrical like using 0/1 guage, high output alt etc.

if its the output board may be ****ed

AmpMedics

or db-r can fix, i has amp medics fix mine replace all outputs and output controller , i also have had one fixed by db-r,

http://www.db-r.com/

these are the only 2 guys i know that have the output control board if it needs to be replaced,

 

[stork90 10+ year member]

well hooked my MM up to the terminals and got a good readout so i checked the ohm load on my speaker wires, got nothing. Took my subs out and found a little prick of a wire that decided to tear itself out. So all is good but thanks for the help!

 

[mclerico83 5,000+ posts]

well hooked my MM up to the terminals and got a good readout so i checked the ohm load on my speaker wires, got nothing. Took my subs out and found a little prick of a wire that decided to tear itself out. So all is good but thanks for the help!

ok thats good, usually when u have no output and everything is correct, and no protect light it means the power supply is bad

 

[bubbagumper6 5,000+ posts]

wait so it was just because the wire fell out of your sub? Everything works now?

 

[stork90 10+ year member]

yea, i didnt think there was any way that was the prob but it turned out it was.

 

[bubbagumper6 5,000+ posts]

secure yo wires better fool!

 

[stork90 10+ year member]

yea lesson learned haha