Fvck, I Need Help!

[sacsking916 5,000+ posts]

They wont back out on there own I meant. But I thought the thread was stripped.

 

[travicles 10+ year member]

Im tryin metric tomorrow... one was pretty stripped already? idk how abut it was... I stopped screwing with them so we will see

I am pretty sure this will work but then again i don't know how badly you tried to force the issue.. i thought i stripped mine but the metric fit right in and brought a smile to my face

 

[Bettr n' Revrse 5,000+ posts]

They arent horrible... like I said the first one was already screwed up some how and I could tell they where stripping so I didnt try and force them...

 

[travicles 10+ year member]

oh well im 99% youre good to go, have a nice day tomorrow!

 

[Bettr n' Revrse 5,000+ posts]

I realy hope that works... if not I may ship them to Corey to have him take them out...

 

[ramos 5,000+ posts]

It's a 3mm screw. Scott made a video the other day //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

 

[Bettr n' Revrse 5,000+ posts]

Im trying metric when I get home but even if I barely put pressure one them with any other allan they just seemed to strip very easily...

 

[ramos 5,000+ posts]

Just make sure the allen driver is seated fully and loosen it slowly. I never even installed them coax lol I pulled the tweets off right out of the box //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

 

[Bettr n' Revrse 5,000+ posts]

I think Ill be ok with a metric... I tried not to screw them up to bad since I could tell they where stripping...

 

[Bettr n' Revrse 5,000+ posts]

They are now comps!

 

[ramos 5,000+ posts]

werd //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif