Original wis
CarAudio.com Regular
This is the best I could figure out for the amp rack. The outside of the tape is where the cuts will be made. 0 gauge will come in from the bottom.
The white is 4 gauge going to the positives on the distribution block and the sub amp.
The red is the grind doing the same.
The green is the 12 gauge power going to the mids and the DSP.
The blue is where the 14 gauge speaker wires for the mids come in from the side.
This is as far as I can get so far. Any advice would be really appreciated.
Thank you
The white is 4 gauge going to the positives on the distribution block and the sub amp.
The red is the grind doing the same.
The green is the 12 gauge power going to the mids and the DSP.
The blue is where the 14 gauge speaker wires for the mids come in from the side.
This is as far as I can get so far. Any advice would be really appreciated.
Thank you
