Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Feedback on my amp rack
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Original wis" data-source="post: 8827651" data-attributes="member: 685344"><p>This is the best I could figure out for the amp rack. The outside of the tape is where the cuts will be made. 0 gauge will come in from the bottom.</p><p></p><p>The white is 4 gauge going to the positives on the distribution block and the sub amp.</p><p>The red is the grind doing the same.</p><p></p><p>The green is the 12 gauge power going to the mids and the DSP.</p><p></p><p>The blue is where the 14 gauge speaker wires for the mids come in from the side.</p><p></p><p>This is as far as I can get so far. Any advice would be really appreciated.</p><p></p><p>Thank you</p><p></p><p>[ATTACH]46768[/ATTACH]</p></blockquote><p></p>
[QUOTE="Original wis, post: 8827651, member: 685344"] This is the best I could figure out for the amp rack. The outside of the tape is where the cuts will be made. 0 gauge will come in from the bottom. The white is 4 gauge going to the positives on the distribution block and the sub amp. The red is the grind doing the same. The green is the 12 gauge power going to the mids and the DSP. The blue is where the 14 gauge speaker wires for the mids come in from the side. This is as far as I can get so far. Any advice would be really appreciated. Thank you [ATTACH]46768[/ATTACH] [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Feedback on my amp rack
Top
Menu
What's new
Forum list
