factory amp and aftermarket amp

  • 1
    Participant count
  • Participant list
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

You can run the SVC subs on the GM-DX871 at 1 Ohm, just lower the gain at the amp. The third sub is too different to run on the same amp as the...
1
967
@1aespinoza I see, so this audio volume leveling is what I was experiencing tapping into the Bose sub wires. Well then, I'm off to check out the...
4
1K
There are a couple that SMD has tested, around $20.00 that should take the wattage from most any HU. If you are tapping into the speaker wires...
3
1K
Got it figured out. The PAC LP7-4 LOC seemed to do the trick, and brought the noise down to a very quiet hiss similar to the stock radio...
4
1K

About this thread

Alphamerica

Junior Member
Thread starter
Alphamerica
Joined
Location
Washington
Start date
Participants
Who Replied
Replies
0
Views
665
Last reply date
Last reply from
Alphamerica
Screenshot_20240518-030709~2.png

1aespinoza

    May 18, 2024
  • 0
  • 0
1000007975.jpg

Mr FaceCaser

    May 16, 2024
  • 0
  • 0

New threads

Top