Dual battery wiring tutorial (and why)

[jco1385 5,000+ posts]

I have a couple of possible issues. The batcaps terminals are like set in, which means I would have to bend the bus bars to be able fit them down in the terminal. You see what I'm saying?

then use short 1/0 pieces. i'm not familiar at all w/ batcap

edit: yes. go with that.

 

[Buck 5,000+ posts]

then use short 1/0 pieces. i'm not familiar at all w/ batcap

It's just that the **** terminals are inset so I would have to bend them down like an inch and then bend them back up.

 

[jco1385 5,000+ posts]

optima > batcap

//content.invisioncic.com/y282845/emoticons/sneaky.gif.7189749b3a3f769e8815b47e8ae87f88.gif

 

[Buck 5,000+ posts]

optima > batcap
//content.invisioncic.com/y282845/emoticons/sneaky.gif.7189749b3a3f769e8815b47e8ae87f88.gif

I don't think so.

But If I bend the bus bars I think it would work. And it would be a hell of a lot easier.

 

[jco1385 5,000+ posts]

you could def bend them. but have fun w/ that.

 

[jco1385 5,000+ posts]

hold up...

inset like this?

just turn them to face each other and bolt that shit up.

edit, that wouldn't work. they would be on opposite sides //content.invisioncic.com/y282845/emoticons/crap.gif.7f4dd41e3e9b23fbd170a1ee6f65cecc.gif

 

[Buck 5,000+ posts]

you could def bend them. but have fun w/ that.

And it would be easier than having like 4 ring terminals on each battery. What If I did a bus bar, but not on the battery? Like I ran some runs of 1/0 from the 2 batcaps to a bus bar that is fused?

 

[jco1385 5,000+ posts]

you could do that too, but i'd measure how much drop you have with all the extra wire/bars.

 

[Buck 5,000+ posts]

you could do that too, but i'd measure how much drop you have with all the extra wire/bars.

Hmmm ya. I don't know, I'm just going to have to mess with it.

 

[jco1385 5,000+ posts]

trial/error.

thats how i learned a lot.

 

[Buck 5,000+ posts]

trial/error.
thats how i learned a lot.

I've had some unlucky trial and error. Not with my system, but just with my truck overall.

Here's a view of the terminals on a batcap:

 

[jco1385 5,000+ posts]

looking at that, could you not use a bit longer bolt with washers to compensate and just go right over the top of them?

like this:

bolt -> bus bar -> washers (to fill the gap) -> batcap.

 

[Buck 5,000+ posts]

looking at that, could you not use a bit longer bolt with washers to compensate and just go right over the top of them?
like this:

bolt -> bus bar -> washers (to fill the gap) -> batcap.

Ya I guess I could. I just haven't messed around with it yet. I'm just thinking, it would be best to use copper materials, right?

 

[99grandprixGT 5,000+ posts]

good stuff.

 

[jco1385 5,000+ posts]

copper would be best, yes. i've personally never used bus's, but i think i've seen aluminum also. but i'd try and go with copper.