Do you need to have a seperate chamber for each sub when going sealed??

Supposedly separate chambers are better for some unknown reason. Usually common chambers are more efficient though and you don't have to worry about getting both chambers the exact same volume or whatever, so odd shaped boxes don't give you a hard time trying to split the volume in half exactly.

 
I used separate chambers so if 1 sub fryz I can still listen to the others. The walls inside the box for the separate chambers make good bracing.
That's what I was told to use separate chambers for. But honestly though, if you fry one of your subs, that's your fault, not the box lol. And ontop of that, who would still keep listening. I would replace the sub.

And on a side note, bracing isn't really needed in sealed applications, build very low SPL in relation to a ported box.

 
Shouldn't make a whole hell of a lot of difference unless you are running them off of more than one amp. Then you may see some cancellation if the amps aren't matched up perfectly. As long as it still is solidly braced I would just run them common chamber for ease of construction.I used to run four and then eventually six sealed tens years ago and never had any issues going common chamber.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

Fuknmovin

10+ year member
CarAudio.com Elite
Thread starter
Fuknmovin
Joined
Location
Palm Desert, CA
Start date
Participants
Who Replied
Replies
6
Views
800
Last reply date
Last reply from
Spooney
IMG_20260516_193114554_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0
IMG_20260516_192955471_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0

New threads

Top