could this be causing a buzz/rattle?

sumone
10+ year member

CarAudio.com Veteran
3,456
0
Midwest
when took off the qform mounted on the outside of the door panel I saw the speaker and the shop had put a dent/abrasion or something in it. cause I can't figure out what this rattle is (this is the passenger side speaker; on the driver side, I took everything off and put it back together and it still sounds fine/no buzzing/rattle).

here is a pic.

 
link no worky

I think I replied to you in a different thread though //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

I suspect it's an ignition problem rather than a transmission problem. Start with the basics: plugs, wires, coils, check engine codes. Does the...
4
1K
Yeah i Yeah I know. I have my sub wired at 4ohm so I can get 300w rms from old amp. It’s 1000w max. And yes that’s the reason I got this pioneer...
40
4K
There is an amp. It is a Recoil RED1800.5. It is a five channel amp however I haven’t even hooked up a sub yet. Working on the other issues first...
6
52
for my amp ground I have it to the paneling in my trunk, secured with a bolt and a nut. I sanded as much as I could, and I used a grind wheel on...
72
7K
Try and use the factory ground wire in the harness instead of chassis ground to see if it makes a difference
3
932

About this thread

sumone

10+ year member
CarAudio.com Veteran
Thread starter
sumone
Joined
Location
Midwest
Start date
Participants
Who Replied
Replies
1
Views
397
Last reply date
Last reply from
Pete
20240723_125956.jpg

Bobbytwonames

    Jul 26, 2024
  • 0
  • 0
20240723_125945.jpg

Bobbytwonames

    Jul 26, 2024
  • 0
  • 0

New threads

Top