Confused, is there a way for me to run my RSD's in a 2ohm load?

[Bipolar 10+ year member]

I'm getting 2 sets of 6.5 Rsd components and I have been looking for a amp to push them, of course they all will push more power at 2 ohms then 4 ohms..How do I run these components into a 2 ohm load or can I buy them in a 2 ohm rather then 4? I have only run subs in parallel to drop the ohms and didn't know if you just do the same with the components or how this works...Or is it even possible?? School a fool...thanks..Joe..

Click to read more...

 

[DejaWiz 5,000+ posts]

You can wire them in parallel, but it's generally not recommended to do so with passive crossovers since it can change the crossover frequencies. Just curious, but why 2 sets? 1 set getting 2x150+ w rms should be plenty for most.

 

[nismos14 5,000+ posts]

1 set is a good suggestion.

 

[Bipolar 10+ year member]

I need a set for the rear and a set for the front..I have to have front and rear fill, I'm weird that way I know..

 

[nismos14 5,000+ posts]

Freakin don't put the tweeters in the back.

 

[brazilianguy 10+ year member]

Freakin don't put the tweeters in the back.

//content.invisioncic.com/y282845/emoticons/rotflol.gif.b453361716769b8110ddefc85ff03cd2.gif

 

[Bipolar 10+ year member]

Freakin don't put the tweeters in the back.

//content.invisioncic.com/y282845/emoticons/confused.gif.e820e0216602db4765798ac39d28caa9.gif WTFN