Just installed this amp http://www.woofersetc.com/index.cfm?fuseaction=product.display&Product_ID=6097
to run my comps, turned it on and all was good.
It played for under a minute (speakers sounded better powered by the HU) and went into protect mode right away, the red light is on.
Turned everything off and when I turn it on the right speaker moves out all the way and pops, that's all it ever does. No smoke, no smell, no heat, nothing ?!?
I had the gains all low, volume low as I just started the thing up.
Unplugged the speakers first, no change.
Unplugged the RCA's, no change.
Unplugged the remote "on" wire (jumped the positive to the remote terminal), no change.
Basically, the amp just sitting there getting 12.4volt engine off 13.65volt motor running goes right into protect mode.
I'm thinking of temporarily hooking up another HU with temp. wiring to see if anything changes. Worth a try ?
Or is this one DOA ?
to run my comps, turned it on and all was good.
It played for under a minute (speakers sounded better powered by the HU) and went into protect mode right away, the red light is on.
Turned everything off and when I turn it on the right speaker moves out all the way and pops, that's all it ever does. No smoke, no smell, no heat, nothing ?!?
I had the gains all low, volume low as I just started the thing up.
Unplugged the speakers first, no change.
Unplugged the RCA's, no change.
Unplugged the remote "on" wire (jumped the positive to the remote terminal), no change.
Basically, the amp just sitting there getting 12.4volt engine off 13.65volt motor running goes right into protect mode.
I'm thinking of temporarily hooking up another HU with temp. wiring to see if anything changes. Worth a try ?
Or is this one DOA ?