- Thread Starter
- #16
I can only run 2 the 2 amps that I have. So I will bridge my amp and run it to the mono on the crossover. Then I will connect the mids and tweets. I guess the "mono" on the crossover had me confused!
Bridging 4 channel amp......
- Thread starter mannyahles
- Start date
- Replies 15
- Views 1K
Activity
No one is currently typing a reply...
Similar threads
That amp does not have the RCA summing feature. You will have to use RCA splitters at the amp. If you already have that, then check the gains.
- Started by BryceCC
- General Car Audio
Bridging the amplifier Mono(LPF)on that sub will work just fine @4ohms
- Started by StuBob5
- Amplifiers
No need to bypass the amp. Most use an LOC that takes the full amped signal and turns it into a flat RCA level signal. Here is the newest I have...
- Started by William Melcic
- General Car Audio
It would also be easy to add an equalizer to have individual rca inputs for all of the channels. A decent one can be had for less than $40...
- Started by RyanJ0022
- General Car Audio
Pretty much. It's just a nice kit.
A solo rite Scarlett 2i2, XLR mic and a loop back cable are my next purchases so I can get accurate phase...
- Started by JoeMama541
- Amplifiers
About this thread
- Start date
- Participants
- Who Replied
- Replies
- 15
- Views
- 1,186
- Last reply date
- Last reply from
- mannyahles
New threads
-
-
Multi speakersHello all, need some wiring advise for some speakers. I have...- Started by 07FLSTC
- Replies: 2
-
Yamaha Ypa-700!Scored this on ebay. Listed as untested. They accepted my...- Started by metalheadjoe
- Replies: 0
-
Do I need maestro?I am looking to replace the factory head unit on my wife's...- Started by ncted
- Replies: 1
-
Difficulty w/ connecting backup cameraDifficulty w/ connecting backup camera Head unit is 2009...
- Started by HandsomeSteve
- Replies: 1