Box for 18" BTL

rollinonD's
10+ year member

Member
Can somebody hook me up with this? My max dimensions are 17" high x 36" wide x 30" deep. I was hoping someone could make a slot port running along the front of the box on the bottom rather than the standard one sided slot port tuned to around 30-32hz. I would like port/ sub forward with a wedge design. I'll have around 3000 rms. If anyone could help that'd be great. Oh yea I'll be using 3/4in birch. Thanks.

 
That would not be possible at all. You would have to have the port on the side if you did port/sub on the front. If you did sub up port back then you could do it along the bottom.

 
lol it can be done ( but would almost be facing up) and be way too little airspace remaining, hence my suggestion of sub up port front. //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

 
Sub OD: 18.500” | 18.500”

Cut ID: 16.750” | 16.750”

would be incredibly close.. i still dont think that it would work as a flat face. and absolutely no room for port under it. would be best sub up port back.... im replying via PM atm.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

rollinonD's

10+ year member
Member
Thread starter
rollinonD's
Joined
Location
Islip, NY
Start date
Participants
Who Replied
Replies
7
Views
638
Last reply date
Last reply from
RAM_Designs
561786595_18427607485102160_7010259965928918509_n.jpg

just call me KeV

    Oct 9, 2025
  • 0
  • 0
561583216_18427455586102160_8141545757991593433_n.jpg

just call me KeV

    Oct 9, 2025
  • 0
  • 0

New threads

Top