bjfish11 5,000+ posts
FisherCustoms.com
The fellas over at SSA might enjoy this one...
This box is 2.45 cubes @ 33hz for a 12" SSA ICON. Customer wanted a flared port as well as a nice raised SSA logo on the back. So what I decided to do, was use 1/2" MDF to make the logo out of. Ran a 3/8" roundover bit over it to give it a nice rounded edge. Was a little worried that I wouldnt be able to carpet over it, and not get any wrinkles, but it turned out to be not so bad.
I actually almost forgot to add the logo to the enclosure. I was just ready to carpet the back panel when I remembered it. So thats why you dont see it installed prior to carpeting.
This box is 2.45 cubes @ 33hz for a 12" SSA ICON. Customer wanted a flared port as well as a nice raised SSA logo on the back. So what I decided to do, was use 1/2" MDF to make the logo out of. Ran a 3/8" roundover bit over it to give it a nice rounded edge. Was a little worried that I wouldnt be able to carpet over it, and not get any wrinkles, but it turned out to be not so bad.
I actually almost forgot to add the logo to the enclosure. I was just ready to carpet the back panel when I remembered it. So thats why you dont see it installed prior to carpeting.