blow throughs on single cab trucks

[atlninja82 10+ year member]

i have 1993 chevy 1500 single cab truck. right now i run two 12" RF p3s's in a 2ft^3 sealed box. i mean its loud i guess but i want something that is a lot louder. like in the 140's. so i was kinda wondering how to do a blow through. i have a tool box. could i put the box and subs in there and then have them facing the cab? is this expensive or could i do it on my own? or maybe a site with a tutorial or something i could look at?

thanks,

-eric

Click to read more...

 

[azimuth 5,000+ posts]

it's not that hard. you'll need an accordian boot.

 

[atlninja82 10+ year member]

how do i cut a hole through the cab? hacksaw? would it be possible to put in my toolbox?

 

[cf2004 10+ year member]

how do i cut a hole through the cab? hacksaw? would it be possible to put in my toolbox?

i have heard of people using sawsalls, air grinder etc.. you wanna find something you think you can control steady. also you want to round your cornors with a holesaw. the boot does not seal well on 90 degree angles.

 

[cf2004 10+ year member]

you might be able to use your toolbox, but i think it would be alot of work. i have seen it done in a magaizne before tho if that counts. haha

 

[JL Audio 5,000+ posts]

i have seen most toolboxes used for storing amps/batts..

be a lot easier to get a bed cover or camper.

seal everything you cut.. rust will come fast if not..