should? ....thats a lot of work to be doing only to tear it out 'if' it doesnt work. //content.invisioncic.com/y282845/emoticons/suicide.gif.a649d21efc0d1fd4890a6428166586c1.gif.
Should work fine.
Well after looking at everything, I dont think I have it in me to try to build that port and fit it in the box. I'll try my current port, if it isn't good, I'll seal the box.just fyi, i tried doing a port like that onece, making a crazy labrynth thing to make the tuning lower, and it makes the port efficency terrible. if you have lots of volume to move, each bend in the port like that you are going to loose a good amount of spl.
its like water rushing through it. once it hits the bend wall thing, its going to have to run around the little wall and it looses its momentum - aka pressure aka spl.
i would advise against a port like that. just my 2 cents.