Amps not getting power

  • 3
    Participant count
  • Participant list

mike115
10+ year member

Member
so i got the speaker wires hooked up went from the rear speaker to the speaker level input thing on a mrp m500. we then hooked it up straight to the batterie and its not getting power, but we know there is power going to it? any help?

 
i dont know we never got it to turn on. we had a positive line going to the batterie and the negative terminal going to the ground. (im new to car audio)

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

When you do find a new Ground spot look for something existing that is tapped. If nothing like that is available make sure you cleanthe area to...
13
3K
How I would approach it is install your new amplifier and start using it. Install a voltage gauge and if you see your voltage lowering then add...
4
387
Additinally, no need to reference "max" anything as those specs are useless. Most of know how to look at specs for a given speaker, amp, HU, etc...
2
528
Hello all. Used to come on these forum quite a bit. I used to compete in IASCA MECA etc. and placed 1st 2x with this setup. Anyway this is my baby...
0
803
You don't need two amps. The speakers come with crossovers to help protect the tweeters.
14
1K

About this thread

mike115

10+ year member
Member
Thread starter
mike115
Joined
Location
minnesota
Start date
Participants
Who Replied
Replies
6
Views
502
Last reply date
Last reply from
mike115
all out.jpg

Popwarhomie

    Jun 2, 2024
  • 0
  • 0
all out.jpg

Popwarhomie

    Jun 2, 2024
  • 0
  • 0

New threads

Top