Amp turns off when..

Yeah.. i've tried setting it to lowest.. middle and max.. and the sub still doesn't bump.. any other ideas?
You can't just randomly set gains.

Please, LEARN how to set your gains properly and FOLLOW MY DIRECTIONS EXACTLY.

If all else fails and you still don't want to take it to a shop, get rid of that amp and buy another -- it's junk anyways.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

It might be "ghetto" by today's standards but I used to run a wire off the battery to a switch then to the amp...back in my youth the Police liked...
15
4K
No need to bypass the amp. Most use an LOC that takes the full amped signal and turns it into a flat RCA level signal. Here is the newest I have...
2
134
It would also be easy to add an equalizer to have individual rca inputs for all of the channels. A decent one can be had for less than $40...
6
366
  • Locked
NVX MVPA1 Best tiny amp Installed a bunch, but have one pushing a sealed 12 @ 2ohm in my daily beater Can bump it all day long and barely gets...
4
666
Amp
This tested well on youtube - not familiar with the brand but it is a pretty standard china build house amplifier...
5
482

About this thread

iLoveKatie

Junior Member
Thread starter
iLoveKatie
Joined
Location
Orange County, Ca
Start date
Participants
Who Replied
Replies
18
Views
2,465
Last reply date
Last reply from
takeabao
1717274743729.png

Doxquzme

    Jun 1, 2024
  • 0
  • 0
Screenshot_20240531-022053.png

1aespinoza

    May 31, 2024
  • 0
  • 0

New threads

Top