wakedreams3
CarAudio.com Newbie
All,
I have a Kicker ZX250.2 amp powering 4 - KM620.2 drivers with seperate tweeters. (If you count the drivers and tweeters there are effectively 8 speakers) Essentially the original install has 2 speakers going to each channel of the amp.
My amp continues to clip out (protection light comes on and kills amp). I have checked voltage at the amp terminals on the Remote Wire and B+…voltage remains high before and after amp turns off (protection light on).
I assume my amp cutting out is because on the speakers it is trying to power?? My thought is upgrade to a 4 channel amp unless I am on the wrong path?
Here are the speaker/tweeter specs:
General
Design 2-way
Tweeter Design 3/4" Dome
Tweeter Composition Titanium
Woofer Composition Injection molded poly
Woofer Surround Santoprene rubber
Specifications
Sensitivity 88 dB
Frequency Response 35 - 21k Hz
RMS Power Range (Watts) 10-65
Peak Power Handling (Watts) 195
Impedance (Ohms) 4
Top-mount Depth (Inches) 2 13/16
Bottom-mount Depth (Inches) N/A
Cutout Diameter or Length (inches) 5 1/8
I have a Kicker ZX250.2 amp powering 4 - KM620.2 drivers with seperate tweeters. (If you count the drivers and tweeters there are effectively 8 speakers) Essentially the original install has 2 speakers going to each channel of the amp.
My amp continues to clip out (protection light comes on and kills amp). I have checked voltage at the amp terminals on the Remote Wire and B+…voltage remains high before and after amp turns off (protection light on).
I assume my amp cutting out is because on the speakers it is trying to power?? My thought is upgrade to a 4 channel amp unless I am on the wrong path?
Here are the speaker/tweeter specs:
General
Design 2-way
Tweeter Design 3/4" Dome
Tweeter Composition Titanium
Woofer Composition Injection molded poly
Woofer Surround Santoprene rubber
Specifications
Sensitivity 88 dB
Frequency Response 35 - 21k Hz
RMS Power Range (Watts) 10-65
Peak Power Handling (Watts) 195
Impedance (Ohms) 4
Top-mount Depth (Inches) 2 13/16
Bottom-mount Depth (Inches) N/A
Cutout Diameter or Length (inches) 5 1/8