Amp Setup for MAW12s

[BigBlueGMC23]

I have purchased 2 Mach5 MAW12s and im not sure what the best amp setup would be...i want to give them somewhere between 400-450 rms each

I just want to know what ohms i sure wire them at and what would be a decent amp for around $250-300

Click to read more...

 

[BigBlueGMC23]

Well ive done some research and i think the best way to run it is at 2 ohms...im am looking for an amp around 200-250 and runs around 350-400 RMS...the Kicker ZX750.1 fits what i need...is it any good? and what would u suggest

 

[mlstrass 5,000+ posts]

Profile AP2000 or PG Octane R15 would work if trying to save some $$$.

I run an AP1000 for my rear stage and an R15 for 2 assassins and both have worked fine for the past 7 months.

Lots of choices out there though...

 

[dragnix 5,000+ posts]

The Maw12s are dual 4, so u cannot run two of them at 2ohms. Ur best bet is to run them at about 1ohm. Hifonics tend to be good budget amps that alot of people on this board use though.

 

[denim 5,000+ posts]

Find a Kicker KX 800.2 on ebay and run them 4 ohms mono. //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif

 

[BigBlueGMC23]

Well right now im leaning toward the AP2000 and running it at 320W x 2 RMS at 4 ohm....does that sound like a good setup?