Amp Question... Help plz!

Seem to have found the problem. I guess I'm not getting adequate voltage from my remote wire. When I run the remote wire directly from the amp to the positive post on my battery my amp would turn on with the power light lit up as usual. After doing some research hifonics suggest adding a relay. So i have a project for tomorrow morning.

 
How did you set your gain?
My gain has always been set a little past half. And it was working fine then all of a sudden while I was driving just turned off. So now I'm wondering why now all of a sudden would my remote wire voltage be bad?? Is this something that could be fixed with adding another battery, big three upgrade?

 
My gain has always been set a little past half. And it was working fine then all of a sudden while I was driving just turned off. So now I'm wondering why now all of a sudden would my remote wire voltage be bad?? Is this something that could be fixed with adding another battery, big three upgrade?
You were probably clipping. And your remote wire could either be burned or loose.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

rick817

Junior Member
Thread starter
rick817
Joined
Location
Arlington, Tx
Start date
Participants
Who Replied
Replies
19
Views
1,619
Last reply date
Last reply from
Falcons
IMG_20260516_193114554_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0
IMG_20260516_192955471_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0

New threads

Top