Amp problem
- Thread starter sq_joshua
- Start date
- Replies 2
- Views 696
-
- Tags
- amp hifonics brutus.
-
2Participant count
-
Participant list
huberoy123 10+ year member
Member
Sign that it may need to be replaced. Did you check you power and ground connections at the amp?
- Thread Starter
- #3
yea but later on im going to disconnect every wire, and try it on my friends wires if it does the same i think i might open it up and check or just buy a new one.
Activity
No one is currently typing a reply...
Similar threads
Using a Y RCA to split signal from amp to amp to give both amps the signal they need from the HU and subs in different /separate enclosures tuned...
- Started by Aaron Johnson
- General Car Audio
Fully test it without the ACR-1. TBH it sounds like an amplifier issue. Try connecting your phone direct to the amp via a 3.5mm to RCA cable. If...
- Started by esb
- Wiring, Electrical & Installation
If a sub's voicecoil fails, it will usually drop impedance causing too much current to go back to the amplifier. The amplifier then protects...
- Started by Jake2727
- Amplifiers 2
Have you checked the fuse block. With time, tight connections can loosen and cause failure. Refresh those contact points and test again. Remember...
- Started by Ruizbra
- Wiring, Electrical & Installation
Mine were as short as possible and still I had issues routing them cleanly
- Started by kanihoncho
- Wiring, Electrical & Installation
About this thread
