Amp and speaker setup

[Xrayt3x1]

Hi, I have a question if this would be alright. I am planning on using a 4 channel amp on 6 speakers. 2 front doors, 2 back doors and 2 on backboard.

I am going to use a JBL club 704 amplifier rated at 2 ohms 100 Watts RMS × 4 or 4ohm 70 Watts RMS × 4 It can also do 4 ohms 145 Watts × 2 with a peak power of 1000 watts

My front door and back door speakers are all the same speakers .
All 4 are 6.5 JBL GT0629 rated at 3 ohms 5w - 125w RMS with a peak power of 180 watts

The pair of speakers on my backboard are 6x9 JBL GT0939 rated at 3 ohms 5w - 200w RMS with a peak power of 300 watts.

I dont have alot of money so would I be able to hook these 6 speakers to my 4 channel amp without causing any harm? And how would I go about hooking them up? 2 front speakers on 1 channel. 2 rear on 2nd channel and the 2 backboard speakers get their own separate channels?

Click to read more...

 

[BCotrell 10+ year member]

Skip one set of the the rears you don’t need em.

 

[Xrayt3x1]

Skip one set of the the rears you don’t need em.

So only buy 2 front speaker and the 2 backboard speakers? Don't buy the 2nd set of backdoor speakers

 

[BCotrell 10+ year member]

Do you have subs? If so consider Bridging the amp and put it just on the front stage

 

[Xrayt3x1]

Do you have subs? If so consider Bridging the amp and put it just on the front stage

I have 1 12in sub but it has its own mono amp

 

[BCotrell 10+ year member]

Jbl speakers can get loud and have decent midbass response. And they can take a lot of power. I would bridge that amp and throw that power on the front