ultimate157 5,000+ posts
Engineering Student
I'm going to be ordering a new in line fuse for my 1/0 welding cable and a distro block for the rear. Gots a few questions:
1/0 welding cable: My friend's dad is an electrical engineer and said the wire can handle 500amps. Should I just go ahead and get the 300amp fuse for this fuse holder? http://www.knukonceptz.com/productDetail.cfm?prodID=FH-20
For the distro block, http://www.knukonceptz.com/productDetail.cfm?prodID=KNF-12,
Should i get both 150A fuses for each side output?
1/0 welding cable: My friend's dad is an electrical engineer and said the wire can handle 500amps. Should I just go ahead and get the 300amp fuse for this fuse holder? http://www.knukonceptz.com/productDetail.cfm?prodID=FH-20
For the distro block, http://www.knukonceptz.com/productDetail.cfm?prodID=KNF-12,
Should i get both 150A fuses for each side output?