6.5 comps on 75w rms

[VIP3R 10+ year member]

what do you guys recommend?

ive been doing my research..

only have 75w rms to work with atm as well.

been looking around...but it seems everyone goes over the RMS anyway..

ive been looking at the pioneer ts-d720c, and id ctx65cs and a few others....

even kicker and the phoenix gold...

i have 6x8s atm and want to upgrade... my current 6x8 get loud

do any of these get loud as well?

thanks

Click to read more...

 

[azimuth 5,000+ posts]

ID and phoenix gold are good choices. never messed with the other 2.

 

[Villeza1 10+ year member]

phoenix gold

 

[Hoodlum007 10+ year member]

ID CTX's all the way sir.

 

[VIP3R 10+ year member]

would they work well off 75 w rms? how loud would they get compared to what i have now?

 

[SicAudio 5,000+ posts]

you need a more efficient speaker to run on 75rms so look at 50-75 rms drivers to get the most from them. the opti line is good so are pg or mbquart f or d series

 

[VIP3R 10+ year member]

any recommendations other than those?

how are the kicker 650.2 (not so great id imagine?) they handle 75w rms though

or do the pioneer ts-d720c get loud?

 

[SicAudio 5,000+ posts]

6-1/2" 2-way Component System (Marine Certified)

Power Handling:

Peak: 600 watts per set / 300 watts each side

RMS: 200 watts per set / 100 watts each side

Aerated Polypropylene Cone

Removable Phase Plug

Butyl Rubber Surround

Neodymium Magnet Structure

Die Cast Aluminum Basket

U.S. & Euro hole patterns to line up with the mounting screw holes of virtually any vehicle

1 1/2” Voice Coil

Polyimide Voice Coil Former for high thermal stability

4-Way Gold Plated Input Terminals Corrosion resistant terminals

Vent Holes in the basket equalize air pressure on both sides of the spider for more linear travel, flatter frequency response and lower distortion

1" Ring Radiator Tweeter

Neodymium Motor Structure with Faraday Cap

High Frequency Waveguide Prevents phase cancellations for smooth, uniform frequency response and wide dispersion

Zoebel Crossover Network flattens the system impedance curve for more efficient power transfer and flatter response

Air Core Inductors with Oxygen Free Copper wire, for wider dynamic range, contrast and punch

Mylar Capacitors

Tweeter Protection Circuit

Gold-plated connectors

Cast-Aluminum heat sink

2nd Order Low Pass Filter

3rd Order High Pass Filter

Frequency Response: 40 - 23,000 Hz

Sensitivity: 92 dB

4 ohm Impedance

 

[VIP3R 10+ year member]

those dont look terrible

 

[SicAudio 5,000+ posts]

polk db pretty **** nice for a mainstream brand //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif

not my favorite but not on my no list by any means lolz

thats why i started selling polk

then there are these: DLS classics //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif bad *** SQ speakers from scandinavia

Woofer size 16,5 cm / 6,5"

Power handling capacity 50 W RMS / 80 W max

Tweeter 16 mm / 0,63"

Frequency range 50-18.000 Hz

Crossover point (Hz) 6000 Hz

Sensitivity 91 dB (1W/1m)

Outer diameter of woofer 165 mm / 6,5"

Magnet size 80 mm / 3,15"

Crossover Cable filter with 12/12 dB slope (LP/HP)

Mounting depth 63 mm / 2,48"

Mounting hole 146 mm / 5,75"

Impedance 4 ohm

notice they have hand made pulp speaker cones?

best sq there is ... paper //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

 

[VIP3R 10+ year member]

those are neat too..

what about the ones i mentioned above? like pioneer and kicker

 

[SicAudio 5,000+ posts]

they are ok at best not horrible but dont pay alot for them

 

[VIP3R 10+ year member]

im just looking for better performance than my 6x8s without paying a fortune and using the 75 w rms i have for now...

thats all

 

[Hoodlum007 10+ year member]

The ID's are rated at 100 watts rms and very efficient on power, 75 watts rms power will get them loud.

 

[VIP3R 10+ year member]

thats good to know!

anyone run them with 75?

like know that for a fact?