4 channel install help

[CAT MAN 5,000+ posts]

so i have a legit question.

because i had a smaller amp before i only have an 8 gauge run to my 4 channel it is efc ofc wire.

but the question is. since i will be running a mb quart onyx 4.60 that does 60x4@4 ohms and 120x4@2 ohms. will the 8 gauge be enough to support the front channels at 2 ohm and the rear at 4-8?

it also has an inline 60a maxi fwiw

Click to read more...

 

[sacsking916 5,000+ posts]

not being a smarta$$ but what would the maximum draw be from that amp?

 

[CAT MAN 5,000+ posts]

not being a smarta$$ but what would the maximum draw be from that amp?

i have no idea. its 120x4@2 ohm so 480 rms? 50a?

 

[sacsking916 5,000+ posts]

i have no idea. its 120x4@2 ohm so 480 rms? 50a?

then yeah you should be just fine with the wire you have. from what i figured your probably only looking at around 40 tops. dont remember what 8gauge is rated for though

 

[CAT MAN 5,000+ posts]

then yeah you should be just fine with the wire you have. from what i figured your probably only looking at around 40 tops. dont remember what 8gauge is rated for though

alright. because it calls for 4 gauge but i went to the wire/amps chard and 8 gauge is good for 500rms. thanks stephen. now you need to come hear what my ish gonna bang like yo

 

[Bggd_GMC 10+ year member]

you decided to get that mb quart amp

 

[CAT MAN 5,000+ posts]

you decided to get that mb quart amp

2 //content.invisioncic.com/y282845/emoticons/sneaky.gif.7189749b3a3f769e8815b47e8ae87f88.gif tha 4.125 was wayy too big so i figured 2 of the 4.60s stacked would be space saving. one comes tomorrow the other one im waiting to buy. also got a kinitek hc2k..... but go to my build log. i will update from there //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

 

[Bggd_GMC 10+ year member]

2 //content.invisioncic.com/y282845/emoticons/sneaky.gif.7189749b3a3f769e8815b47e8ae87f88.gif tha 4.125 was wayy too big so i figured 2 of the 4.60s stacked would be space saving. one comes tomorrow the other one im waiting to buy. also got a kinitek hc2k..... but go to my build log. i will update from there //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

sweeeet, ill check it out