ThxOne Premium Member
The Boss
Where should I set the crossovers initially? Before I do an RTA or anything like that... Literally the starting point with all EQ's flat and no enhancements. Here are the speaker sizes and locations:
Alpine 38mm Tweeter - High in the door, factory location, off axis. (Alpine says 800 - 45Khz [-10db]) (4ohm)
Digital Design 2.75" Midrange - Middle Lower door, Just above the woofer, factory location, off axis (160 - 20Khz) (4ohm)
SilverFlute 6.5" Woofer - Lower door, factory location, off axis (50 - 3... 4... 5Khz?) (4ohm)
NO REAR SPEAKERS
Dayton Ultimax 10" Subwoofer - Trunk, shredder2 box design, non directional (25 - 1.5Khz) Dual 2ohm (1ohm)
I have read so many different post and there are so many crossover points... but where to start with a given speaker size?
Alpine 38mm Tweeter - High in the door, factory location, off axis. (Alpine says 800 - 45Khz [-10db]) (4ohm)
Digital Design 2.75" Midrange - Middle Lower door, Just above the woofer, factory location, off axis (160 - 20Khz) (4ohm)
SilverFlute 6.5" Woofer - Lower door, factory location, off axis (50 - 3... 4... 5Khz?) (4ohm)
NO REAR SPEAKERS
Dayton Ultimax 10" Subwoofer - Trunk, shredder2 box design, non directional (25 - 1.5Khz) Dual 2ohm (1ohm)
I have read so many different post and there are so many crossover points... but where to start with a given speaker size?