key word there is should. If an amp is built to see a nominal impedance of 4 and you show it 3, the low end impedances itll see are way lower than what the amp is built to see and bye-bye amp. In his case, its probably for the best that it does as it isnt a known brand to the community and its not ideal for a sub amp anyways. Sorry to say man, your amp is probably gonna fry if you push it at all, and im not sorry to say that its probably for the best in your situation. Cheap mono amps can be had for 100 usd thatll kick the hell out of that thing for subs. Use that on mids and highs and be done with this questionThere should not be any issues running a 3 ohm speaker to a 4 ohm, as the resistance changes with different frequencies so it should not be a hazard to the amplifier provided your amp can handle to a certain low impedance. Speakers vary in different frequencies during music so it fluctuates when used so that should be ok mate!
View attachment 3739
Lol you don't the protection circuit will work in that amp?key word there is should. If an amp is built to see a nominal impedance of 4 and you show it 3, the low end impedances itll see are way lower than what the amp is built to see and bye-bye amp. In his case, its probably for the best that it does as it isnt a known brand to the community and its not ideal for a sub amp anyways. Sorry to say man, your amp is probably gonna fry if you push it at all, and im not sorry to say that its probably for the best in your situation. Cheap mono amps can be had for 100 usd thatll kick the hell out of that thing for subs. Use that on mids and highs and be done with this question
im thinking that the amp wont last long even if it was ran on the correct impedance load. didnt he say that 2 channels of it were already dead in another thread?Lol you don't the protection circuit will work in that amp?
Yeah I don't either..
Personally with that small set up I'd invest in a 5 channel amp and retire that amp all together..
Idk. Some of the cheap af amps are hard to kill. It looks like it's been around the block a few timesim thinking that the amp wont last long even if it was ran on the correct impedance load. didnt he say that 2 channels of it were already dead in another thread?