2 Amps?

Nsignificant

Junior Member
I'm a complete newbie when it comes to amps/subwoofers. I recently installed my Kenwood KVT-614 with the KNA-G510 navigation, so I can understand basic concepts of wiring etc. But my question is, I have 4 stock speakers, which I am going to replace, and I want to power them a 4-Channel amp, I'm also going to buy 2 12" subs in a box, and buy a separate 2 channel amp for that.

What kind of wattage will my speaker amp need? Also do I need crossovers and tweeters?

Thank you

 
you most likely want a mono amp for your subs, unless you have 2 dvc4s that you are wiring in series at 4ohm...what kind of subs and door speakers?

 
look at the rms on your speakers not the peak power and get an amp that matches the rms...then you will be safe...all tweeters need crossovers of some sort either active or passive are they will smoke....
Do I really need tweeters though? Will it make a noticeable difference? Also, I'm not entirely sure on the brand/type of speakers/subs I'm getting, my ceiling is $750 and they must be purchased from Best-Buy (I know Bestbuy is bad for this type of thing, but It must be from bestbuy). So any suggestions/comments would be appreciated.

Thanks again.

 
Using a best but credit card huh? If I were u I would get the alpine F300 and M500. Decent prices and decent sound...both are around $200 and $240. I would also try the alpine type e single vc subs at this level there about 130 each that leaves u tax and wiring money. They sell kicker kits...there nice and worth it use 4awg dual amp kit its got all the parts u will need. They should also sell speed wire. Buy this its way easier to use it for your 4ch install

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

How I would approach it is install your new amplifier and start using it. Install a voltage gauge and if you see your voltage lowering then add...
4
208
Additinally, no need to reference "max" anything as those specs are useless. Most of know how to look at specs for a given speaker, amp, HU, etc...
2
445
Hello all. Used to come on these forum quite a bit. I used to compete in IASCA MECA etc. and placed 1st 2x with this setup. Anyway this is my baby...
0
713
You don't need two amps. The speakers come with crossovers to help protect the tweeters.
14
1K
Perhaps you changed something without mentioning it here? Maybe a loose turn on line? I dunno man...but we'll take it. Hopefully it keeps working. 👍
16
2K

About this thread

Nsignificant

Junior Member
Thread starter
Nsignificant
Joined
Location
Wisconsin
Start date
Participants
Who Replied
Replies
6
Views
537
Last reply date
Last reply from
FenixAudio
1000008028.jpg

Mr FaceCaser

    May 20, 2024
  • 0
  • 0
1000008027.jpg

Mr FaceCaser

    May 20, 2024
  • 0
  • 0

New threads

Top