12" woofer that does work on lows?

I believe I have narrowed my choice down to either 1-2 RE MT 12's, or 1-2 Mach5 IXL 12's. I don't know much about the RE MT's but a single IXL 12 recommends 1.4 Cu. Ft ported and can handle a lot of power. With two, they should fit perfectly in the space I have. If I do decide to run two Mach5 IXL's, dual 1ohm, ported box tuned around 28hz, what kind of amp and port type should I look into?

 
The MT and IXL are quite different subs. MT's are known for their loudness and being able to handle a ton of power. They'd more than likely need a good deal more power than the IXL's if you're stuck on using a smaller size box. You will definitely need electrical upgrades if you plan on properly powering a pair of MT's in a 3ft^3 box(which I wouldn't even recommend for them).

The IXL's are more geared towards sound quality than just being able to get loud. Put a pair in 3ft^3 tuned to 28hz and you'll have some good sound. Go with a lager box and you'll get even better low-end out of your subs. Just keep in mind that doing a 3ft^3 box for a pair of 12's tuned to 28hz, with adequate port area, will require a very long port. It'll probably take up 1.5-2ft^3 by itself.

Since you said yourself that you're not that hung up on SQ, go ahead and get a pairs of SA-12's. They're loud as balls and will work well in a 3-3.5ft^3 box for a pair.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

LowNotes

10+ year member
Junior Member
Thread starter
LowNotes
Joined
Location
South Carolina
Start date
Participants
Who Replied
Replies
21
Views
1,585
Last reply date
Last reply from
Silver
1778763859842.png

Doxquzme

    May 14, 2026
  • 0
  • 0
IMG_20260513_214311575.jpg

ThxOne

    May 13, 2026
  • 0
  • 0

New threads

Top