Recent content by Team Maxxsonics

Same electronics...differant cosmetics. I can assure you, there is no one that knows this better then me......

This is the kind of information that just bugs the carp out me. Where did you get this information from...another person on some other forum? You do know that amplifiers are made of extruded alluminum right? Plastic end panels have been used for years and by nearly every amplifier company in...

The LOC's in amplifiers are typically not very good because of the cost it adds to every amp and because they are rarely needed, they are the least expensive solution available. You may want to consider the Maxxsonics MX-1 Add-A-Sub. It is specifically designed for adding a sub amp to a...

The Titan series were a very good amplifier just below the Zeus series back then. The power is 2 x 150 watts RMS.

If you are unable to send them to ZED, contact Audio Clinic at 805 390-0119 and ask for Mike Nichols. Mike was a Hifonics engineer back then with ZED and has an amplifier repair shop.

AB500.1 They are local, they service the amps and Bob is a great guy.

The problem is very likely your remote turn circuit not providing enough voltage or is current limited. 1. Disconnect the remote wire from the amp. 2. Place a jumper wire from the amp remote terminal to the amp + battery terminal. 3. If the green light turns on...your remote turn on is the...

Yes but use a "Y" adapter so you are not brining in a stereo signal.

Are you saying that the TOTAL current drain from your car is 7 milliamps? If so, how did you measure this? Did you use a shunt? Your vehicle electronics and radio memory should draw more then this by them selves. 7ma. is not a lot of draw...most cars draw more then this. A little more info...

It may an A/B-Class mono amp that is strappable (master/slave). Got a link?

MB Quart Q4.150 4 Channel Amplifiers - Car Amplifiers at Onlinecarstereo.com Note: They accidentally put 150 x 1 at 4-Ohms but it's a typo...should be 150 x 4 at 4-Ohms.

You said in item: "#3. When the amp is off, the DMM reads 12v at power and 12v at remote." Are you having this problem when the engine is running or off? Either way, you should have had a higher voltage reading (12.5-12.9 engine off and 13.6-14.4 engine running). It's best for you to be very...

Actually, we did (twice) but at a $1.00 a watt, very few bought it. Everyone wants high end but not enough are willing to pay for it.

Wow.... nice find!