Recent content by Mind_nl

20 farad cap? are you sure that's not 2.0 farad

you have to hook them up like this (in series)

check your groundings! what HU do you have?

you have to securely mount it to prefent the HU from vibrating add some sort of bracket to the back of the HU, also some dynamat could help...

I would mount them in the pillars pointing to your ears...

how are your amps connected? sounds like they stay on while turning off the car causing the battery to be discharged

audio in/out on what? If you are talking about connectors on your DVD player: it sends the audio OUT, so that is where you hook up your speakers...

so your running a 4 ohm load over a 8 ohm amp? That is not good, not good at all...

are you getting power on your remote wire? use a multi meter to check...

Take your multi-meter and look for a cable that is hot +12V when your lights are on and 0V when they are turned off... Thats where the Illumination wire goes. I'm not sure about your dimmer wire, what does the manual tell you this is for? Another thought: what if both cables are disconnected...

Thats what the 'remote' wire running from you HU to the amp is for...

All it changes is the direction the speaker cone will move. so the inverted one will move down when the other one moves up and since the one is inverted they will both move up at the same time. If you would have them both normally installed and you would switch one speakers polarity they would...

Yep, reverse the inverted one or they will be cancelling out each other

Oke, so it doesn't do anything? try hooking it up directly to a 12V battery. The BATT (yellow) and the ACC (red) go onto the + terminal the ground wire (black) onto the - terminal... See if it does anything then...

Np......