07 Mustang Shaker500 head unit swap questions

  • 1
    Participant count
  • Participant list

Lhnetman

CarAudio.com Newbie
1
0
I’m replacing the factory Shaker500 head unit with a Kenwwod Excelon one. The factory setup has 8” sub in each door. The Metra harness that is needed has a rca that plugs into the aftermarket “sub out”. My question is how do I add a sub in the rear? Do I just “split” the output(y-adatpors) so both amp receives the signal?

Thanks 

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Could not tell you, but you may want to start by going to crutchfield and get a consensus on the 7 or so replacements they recommend. That average...
1
665
Might not even be an issue if you don't have any really big panels on it. Otherwise dowels or threaded rod across your wide panels would be the...
18
2K
I ordered the car with the upgraded B&O audio system....turn's out Ford bought the name but they didn't buy the quality. The system ****** to me...
0
903
Contact ANS he has a used Focal 8 Channel DSP that went for 1,300 bucks and is selling used I think shipped for 450. And from what I have seen and...
13
2K
One or two, they are still subwoofer outs and are mono summed signals from both left and right. Even the 2 RCA subwoofer pre-outs on the 2nd one...
3
174

About this thread

Lhnetman

CarAudio.com Newbie
Thread starter
Lhnetman
Joined
Location
Start date
Participants
Who Replied
Replies
0
Views
404
Last reply date
Last reply from
Lhnetman
audio3.jpg

pfft

    May 1, 2024
  • 0
  • 0
audio2.jpg

pfft

    May 1, 2024
  • 0
  • 0

Latest topics

Top